Installation guide

Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
Revision 2.7 Page 35 of 83
Mercury Plant Controller Installation Guide
P268
P279
Section 2 Stage 3 Relay 1
Section 2 Stage 3 Relay 12
0 = off
1 = on
1
-
0
P280
P291
Section 2 Stage 4 Relay 1
Section 2 Stage 4 Relay 12
0 = off
1 = on
1
-
0
P292
P303
Section 2 Stage 5 Relay 1
Section 2 Stage 5 Relay 12
0 = off
1 = on
1
-
0
P-304
P315
Section 2 Stage 6 Relay 1
Section 2 Stage 6 Relay 12
0 = off
1 = on
1
-
0
P316
P327
Section 2 Stage 7 Relay 1
Section 2 Stage 7 Relay 12
0 = off
1 = on
1
-
0
P328
P339
Section 2 Stage 8 Relay 1
Section 2 Stage 8 Relay 12
0 = off
1 = on
1
-
0
P340
P351
Section 2 Stage 9 Relay 1
Section 2 Stage 9 Relay 12
0 = off
1 = on
1
-
0
P352
P363
Section 2 Stage 10 Relay 1
Section 2 Stage 10 Relay 12
0 = off
1 = on
1
-
0
P364
P375
Section 2 Stage 11 Relay 1
Section 2 Stage 11 Relay 12
0 = off
1 = on
1
-
0
P376
P387
Section 2 Stage 12 Relay 1
Section 2 Stage 12 Relay 12
0 = off
1 = on
1
-
0
dFLt
Restore Default Settings
(Front panel Only)
ESc
* Span and Offset allows for the full range of the transducer to be used by the controller.
Span is the full range of the transducer
Offset is the value below zero.
Note. The controller uses absolute pressure; if gauge pressure is required, add +1 Bar to the offset value.
Example: Danfoss AKS 33 with range: -1 bar to 12 bar
Span would be 190 (13 bar)
Offset would be -15 (-1 bar)