User guide

Revision 7.1b Page 4 of 31
Mercury Coldroom Panel Installation Guide
www.resourcedm.com
Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
The Mercury Range
From Resource Data Management
The Mercury Coldroom panel has been specifically developed to suit a variety of coldroom needs. The purpose developed enclosure has
a detachable display/keypad for applications where the main enclosure is required to be “out of reach”. The panel is available with or
without a main isolator switch. Each internal circuit has either fuse or circuit breaker protection.
Based on Mercury technology, the controller has parameters that give this product complete flexibility for controlling either produce (HT)
or freezer coldrooms (LT).
Coldroom lights can be configured for maximum energy saving by using a timer (local or remote) to enable the lights and using the “lights
on when door is open” feature. A front panel over-ride switch is available when the door needs to be closed and the lights are required to
be on.
NB – Please be aware new software builds are not compatible with some older versions of hardware. These can be identified by
controllers using V6.4 (E) / V6.3 (M) and below. With these older boards software V6.4 is the latest update.
Networks
The panel is capable of connecting to either a TCP/IP local area network (recommended) or a RS485 network or controlling in
standalone mode with no network output. The built-in communication options are determined by the part number of the coldroom panel.
See Parts Numbers section for more information.
For non network versions it is possible to connect the Coldroom panel to the following network interfaces: -
Description
Part Number
IP Futura (Single Mercury to IP Interface)
PR0016
RS485 Interface (Single Mercury to RS485 Interface)
PR0026
Mercury IP Switch (IP support for 10 controllers)
PR0018
Mercury IP Switch with Pressure/Humidity Inputs
PR0018-PHI
Configuration
The Coldroom Panel (both the EEV and Compressor/LLV versions) has 2 types: -
Display value
Type
1
LT Coldroom
2
HT Coldroom