User guide

Revision 7.1b Page 26 of 31
Mercury Coldroom Panel Installation Guide
www.resourcedm.com
Warning
Please Note
The specifications of the product detailed on this
Set-Up Guide may change without notice. RDM
Ltd. shall not be liable for errors or for incidental
or consequential damages, directly and indirectly,
in connection with the furnishing, performance or
misuse of this product or document.
Ensure that all power is
switched off before
installing or maintaining
this product
Lights: 6A (non inductive) 6A CosФ=0.4
Switched Output Voltage: Same as supply voltage
Out 1: 5A
Permanent Output Voltage: Same as supply voltage
Out 2: 1A
Permanent Output Voltage: Same as supply voltage
Inputs
Probes:
Input type Selectable
Entrapment and Door alarms 0V return
Comms: RS232 with flow control
Ethernet (IP) 10BaseT
RS485 Genus compatible
Installation
Fixing
The Coldroom Panel has 4 fixing holes: - (dimensions are in mm and inches)
200mm
(7.87in)
175mm (6.89in)
Knockout for 25mm cable gland/coupling or
suitable conduit or trunking
25mm cable gland/coupling or suitable conduit or
trunking
The enclosure has knockouts for eight 25mm cable glands, four
at the top and four at the bottom. Suitable cable glands, trunking
or conduit must be used for correct installation of cabling.