User's Guide

2928
8.5.1 Tele loop systems
To use tele loop systems, follow these steps:
1. Switch your hearing aid to the Telecoil programme.
2. Find a good spot. Reception is not clear in all locations; it depends on the induction loop. Look for
signs or find another spot to sit.
3. If needed, adjust the volume.
4. When you leave, switch to programme 1.
8.5.2 HAC Telephone
The telecoil picks up the HAC telephone’s telecoil signal and converts it to sound.
To use the HAC telephone, follow these steps:
1. Switch your hearing aid to the Telecoil programme.
2. Pick up the telephone and place a call or answer a call.
3. Hold the telephone behind your ear – close to the hearing aid, and tilt it slightly outwards.
4. Listen to the dialling tone and move the telephone to get the best reception.
5. If needed, adjust the volume.
6. When you hang up, switch to programme 1.
i
NOTE: If the phone has a poor telecoil signal, use the microphone programme. To avoid whistling,
do not hold the handset too tightly against your ear.
8.6 Flight mode (optional)
i
WARNING: When boarding a flight or entering an area where RF transmitters are prohibited, wire-
less functionality must be deactivated.
Your LiNX 3D hearing aid allows you to control it from your smart phone or ReSound Remote Control.
However, in some areas you are requested to turn o wireless communication.
Follow these steps to turn o wireless mode:
1. For each hearing aid, open and close (open-close, open-close, open-close) the battery door three
times within a 10-second period.
2. Double-dings for ten seconds ( etc.) indicate that your hearing aid is in Flight mode.
Follow these steps to activate wireless mode:
1. For each hearing aid, open and close the battery door once.
2. Your hearing aids are in wireless mode after 10 seconds.
i
NOTE: Both hearing aids must be set in Flight mode - even with synchronisation enabled.
NOTE: It is important to wait an additional 15 seconds after wireless function resumes before
opening and closing the battery door again for any reason. Flight mode will resume if you open
and close the battery door during this 15-second window.
NOTE: Flight mode must be activated by clinician in order to be controlled.