SDS

D8329987 v6.0
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
hydrogen peroxide solution
ACGIH TLV (United States, 3/2018).
TWA: 1 ppm 8 hours.
TWA: 1.4 mg/m³ 8 hours.
OSHA PEL 1989 (United States, 3/1989).
TWA: 1 ppm 8 hours.
TWA: 1.4 mg/m³ 8 hours.
NIOSH REL (United States, 10/2016).
TWA: 1 ppm 10 hours.
TWA: 1.4 mg/m³ 10 hours.
OSHA PEL (United States, 5/2018).
TWA: 1 ppm 8 hours.
TWA: 1.4 mg/m³ 8 hours.
8. Exposure controls/personal protection
Ingredient name
Exposure limits
Hand protection
Based on the hazard and potential for exposure, select a respirator that meets the
appropriate standard or certification. Respirators must be used according to a
respiratory protection program to ensure proper fitting, training, and other important
aspects of use.
Considering the parameters specified by the glove manufacturer, check during use that
the gloves are still retaining their protective properties. It should be noted that the time
to breakthrough for any glove material may be different for different glove
manufacturers. In the case of mixtures, consisting of several substances, the protection
time of the gloves cannot be accurately estimated.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: chemical splash goggles.
Eye/face protection
Respiratory protection
:
:
:
Body protection
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Hygiene measures
:
Control
Individual protection measures
Occupational exposure limits
Skin protection
Other skin protection
:
Appropriate footwear and any additional skin protection measures should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling this product.
5/13
01/29/2020
Date of issue
:
SDS #
FF8320891_D8329987
US
:
Code #
D8329987 v6.0
: