SDS

D8360520 v2.0
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
7. Handling and storage
Conditions for safe storage,
including any
incompatibilities
Store in accordance with local regulations. Store in original container protected from
direct sunlight in a dry, cool and well-ventilated area, away from incompatible materials
(see Section 10) and food and drink. Store locked up. Keep container tightly closed
and sealed until ready for use. Containers that have been opened must be carefully
resealed and kept upright to prevent leakage. Do not store in unlabeled containers.
Use appropriate containment to avoid environmental contamination.
:
Protective measures
Put on appropriate personal protective equipment (see Section 8). Do not get in eyes or
on skin or clothing. Do not breathe vapor or mist. Do not ingest. If during normal use
the material presents a respiratory hazard, use only with adequate ventilation or wear
appropriate respirator. Keep in the original container or an approved alternative made
from a compatible material, kept tightly closed when not in use. Empty containers retain
product residue and can be hazardous. Do not reuse container.
:
Precautions for safe handling
Not applicable.
8. Exposure controls/personal protection
Hand protection
Considering the parameters specified by the glove manufacturer, check during use that
the gloves are still retaining their protective properties. It should be noted that the time
to breakthrough for any glove material may be different for different glove
manufacturers. In the case of mixtures, consisting of several substances, the protection
time of the gloves cannot be accurately estimated.
Safety eyewear complying with an approved standard should be used when a risk
assessment indicates this is necessary to avoid exposure to liquid splashes, mists,
gases or dusts. If contact is possible, the following protection should be worn, unless
the assessment indicates a higher degree of protection: chemical splash goggles and/
or face shield. If inhalation hazards exist, a full-face respirator may be required instead.
Eye/face protection
:
:
Body protection
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
:
If user operations generate dust, fumes, gas, vapor or mist, use process enclosures,
local exhaust ventilation or other engineering controls to keep worker exposure to
airborne contaminants below any recommended or statutory limits.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Hygiene measures
:
Control
Individual protection measures
Occupational exposure limits
Skin protection
Other skin protection
:
Appropriate footwear and any additional skin protection measures should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling this product.
5/13
10/04/2019
Date of issue
:
SDS #
FF3086009_D8360520
(US)
:
Code #
D8360520 v2.0
: