Installation Guide

ManualsBrandsResolution Products ManualsElectronicsLED Keypad

LED Keypad is a table or wall mounted interface that chimes

and uses lit keys and an LED light bar to provide visual

arming status. The LED Keypad can be battery operated or

AC powered for exible installs.

Features

• Displays real-time status

• Wall or table mount

• AC or battery primary power

• 1 year battery life for battery primary power

• User replaceable AA batteries

Use the panel installation guide to verify proper system setup.

RE663 LED Keypad

Connect+

™

Encrypted

Enroll by placing the panel and LED Keypad into wireless enrollment mode. Press the enroll

button on the side of the panel to put the panel into wireless enrollment mode. Hold 1 and 3

simultaneously for 3 seconds on the Keypad to put the Keypad into wireless enrollment mode.

Operate using the LED Keypad buttons.

Light bar

• Indicates arming level with color (Disarm - Green, Stay - Cyan, Away - Red,

Night - Blue).

• Amber corners indicate trouble condition.

• AC powered operation uses full light bar. Light bar "breathes" if zones are open.

• Battery operation uses light bar corners. Light bar blinks periodically and will

double blink periodically if zones are open.

Disarm

• Indicates Disarmed

• Cancel Force Arm

• Silence Trouble beeps

(w/code if required*)

0-9/User Code

• Disarm

• Force Arm

• Arm if required*

• Silence Trouble beeps

if required*

• Press and hold 1 & 3 for

(Un)Enrollment

Stay/Away/Night

• Change/Indicates

Arming Level

• Hold Night for 3

seconds to turn

display off

Silent Arm

• Silent Arm or Disarm

Modier

• Press and hold with

number to change

volume

Instant Arm

• No Entry Delay Modier

• Press and hold with

number to change

brightness

*Depends on panel settings

(Quick Arm, UL, etc.)

Panic Alarm Trigger

Press and hold the * and #

buttons for 3 seconds

Summary of content (4 pages)

PAGE 1
IN STA I LL UID E G RE663 LED Keypad Connect+™ Encrypted LED Keypad is a table or wall mounted interface that chimes and uses lit keys and an LED light bar to provide visual arming status. The LED Keypad can be battery operated or AC powered for flexible installs.
PAGE 2
Keypad Mounting Options Table Top Mounting 1. Insert batteries into Keypad following polarity markings. 2. Route power cable through wire window in table stand. Connect the power supply by inserting the barrel plug into the black port. Orient the barrel plug as shown. Wire window Barrel plug 3. Insert the Keypad into the table stand. Push any extra wire into stand before inserting into stand. Slide the Keypad on stand until it "clicks" into place. 4. Coil up the excess power wire into the stand.
PAGE 3
Wall Mounting 1. Insert batteries into Keypad following polarity markings. 2. Fasten to wall by screwing the screws through the two holes into the wall. Screws should be fastened to a stud, a single gang box, or with wall anchors into drywall. Ensure power supply wires are routed through wire window and seated in wire channel if wire does not run behind drywall. Screw hole Wire window Screw hole Wire channel 3. Route power cable using one of two methods. A.
PAGE 4
Pro Tips Wire can be hidden by running the wires through a hole behind the wall mounting plate and along the back side of the drywall to a location with an outlet. Switching to battery primary power can be done by restarting the keypad with the battery power. First, remove wall power supply and batteries. Wait 10 seconds. Then, power the keypad back up with only batteries. Unenrollment can be done by following the same steps as enrollment. Force unenroll can be done when no panel is present.