Installation Instructions

Regulatory Information
FCC Information
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2)This device must accept any interference received, includinginterference that may cause undesired operation.
Note: This product has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of
the FCC Rules. Theselimits are designed to provide reasonable protection against harmfulinterference in a residential
installation. This product generates, uses,and can radiate radio frequency energy and, if not installed and used
inaccordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference willnot occur in a particular installation. If this product does cause harmfulinterference to radio
or television reception, which can be determined byturning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Please take attention that changes or modification not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment.
This equipment should be installed and operated with a minimumdistance 20cm between the radiator and your body.
Industry Canada ICES-003 Compliance
This device meets the CAN ICES-3 (B)/NMB-3(B) standards requirements.
This device complies with Industry Canada licence-exempt RSSstandard(s). Operation is subject to the following two
conditions:
(1) this device may not cause interference, and
(2)this device must accept any interference, including interference thatmay cause undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or
lesser) gain approved forthe transmitter by Industry Canada. To reduce potential radio interference to other users, the
antenna type and its gain should be so chosen thatthe equivalent isotropically radiated power (e.i.r.p.) is not more than
thatnecessary for successful communication.
This equipment complies with IC RSS-102 radiation exposure limits setforth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & yourbody.
(i)the device for operation in the band 5150-5250 MHz is only for indooruse to reduce the potential for harmful interference
to co-channel mobilesatellite systems;
(ii)the maximum antenna gain permitted for devices in the bands 5250-5350 MHz shall comply with the e.i.r.p. limit; and
(iii)the maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the e.i.r.p. limits
specified for point-to-point and non point-to-point operation as appropriate.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
ce matériel est conforme aux limites de dose d'exposition aux rayonnements, FCC / CNR-102 énoncée dans un autre
environnement.cette eqipment devrait être installé et exploité avec distance minimale de 20 entre le radiateur et votre
corps.
(i)Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l'intérieur