Instructions / Assembly

Back Panel (1PC)
(B)
(D)
(C)
Front Legs (2PCS)
Seat (1PC)
(A)
STEP-BY-STEP ASSEMBLY:
Arms
(2PCS)
Back Seat
Beam (1PC)
(E)
Back
Back
Front
Attach Front Legs (C) to Seat (A) by
inserting 3x 2.55” Bolts (H) on each side into
the corresponding holes. Secure each bolt with
a Washer (G) and Nut (F) as pictured.
Attach the front part of the Arms (D) to the
Front Legs (C) using 2.55” Bolts (H) and secure each
bolt with a Washer (G) and Nut (F) as pictured.
Attach the Back (B) to Seat (A) using 2.4”
Screws (J). Then attach the Back (B) to Arms (D)
using 3.15” Screws (L) as pictured.
I
Attach Back Seat Beam (E) between the
rear legs using 2.4” Screws (J) as pictured.
A. Seat - 1Pc
B. Back - 1Pc
C. Front Legs - 2Pcs
D. Arms - 2Pcs
E. Back Seat Beam - 1Pc
F
G
H x3
H
F
G
H
H
J
ResinTEAK
F. Lock Nut - 8Pcs
G. Washer - 8Pcs H. Bolts 2.55” - 8Pcs
J. Screws 2.4” - 4Pcs
L. Screws 3.15” - 2Pcs
M. Allen Wrench - 1Pc N. Wrench - 1Pc
STEP 1:
STEP 2:
STEP 3:
STEP 4:
*IMPORTANT NOTE: DO NOT OVERTIGHTEN THE BOLTS*
Tighten all bolts and screws after assembly is
complete.
J