Wiring Guide

R8182D,H COMBINATION PROTECTORELAY™ PRIMARY CONTROL AND AQUASTAT
®
CONTROLLER
69-0599—2 8
Fig. 12. Setting stop in position to restrict low limit
setting to 180°F (82°C) or lower.
Startup
WARNING
Explosion Hazard.
Can cause severe injury, death or property
damage.
Be sure combustion chamber is free of oil or
vapor.
1. Push red reset button and release.
2. Open hand valve on oil supply line.
3. Set thermostat to call for heat.
4. Close line switch; burner will start.
5. Under normal conditions, burner operates until
thermostat is satisfied or line switch is opened.
Make certain the system operates as described in the
OPERATION section. Use the following procedure to
verify that the Protectorelayª control is controlling
properly.
Flame Failure Check
Shut off the oil supply hand valve while the burner is on.
After 45 seconds, the safety switch locks out, the motor
stops, and the oil valve closes. Allow five minutes for the
burner to cool, then manually reset the safety switch.
Ignition Failure Check
Test by closing the oil supply while the burner is off. Run
through the starting procedure, but do not open the oil
supply line hand valve. The safety switch locks out as in
flame failure. Then turn the oil back on, and reset the
safety switch.
Power Failure Check
Turn off the power supply while the burner is on. When
the burner goes out, restore power and the burner will
restart.
NOTE: If operation is not as described, see cover insert
for additional information and check the wiring.
Aquastat Replacement
The Aquastat controller section of the Protectorelay
control is field replaceable. When ordering a replacement
assembly, specify the complete model number of the
R8182.
To replace the Aquastat Controller:
1. Disconnect power supply.
2. Note position of connecting wires.
3. Remove fastening screws and wires.
4. Remove Aquastat controller and install new
assembly.
MATERIAL SAFETY DATA SHEET (MSDS)
SECTION 1. PRODUCT AND
COMPANY IDENTIFICATION.
Product Name: Heat conductive compound.
MSDS ID: DS9021.
Synonyms: MS1699.
Product Use: Heat conductive material used to enhance
contact and heat transfer in temperature sensor
applications.
Manufacturer: Honeywell Inc., 1985 Douglas Drive North,
Minneapolis, MN 55422.
Date Released: October 8, 1999.
Emergency Telephone Information: 1-888-809-3787.
NFPA Ratings:
Health 0; Flammability 1; Reactivity 0; Personal
Protection B.
200
160
140
180
SETTING STOP
STOP ARM
SETTING
PROJECTION "A"
KNOB SET AT 140 F (60 C)
M4523
1
1
SCALE MARKINGS IN FAHRENHEIT ONLY.
120