Installation Guide

DCN: 140-02338-01 DRAFT 20619
Page 19
Z-Wave
®
Operation
Thermostat Battery Operation: If the thermostat is installed in a Z-Wave network while
powered by batteries, it will be enrolled as a Z-Wave FLiRs type device. This is a power
saving mode that conserves the batteries by keeping the radio asleep most of the time.
However, in this mode, the thermostat does not act as a repeater/router in the Z-Wave
network.
Thermostat 24VAC Operation: If the thermostat is installed in a Z-Wave network while
powered by 24VAC, it will be enrolled as an always-listening device and can act as a router
node in the Z-Wave network.
Caution! Once installed in a Z-Wave network, if you change how the thermostat is
powered (from batteries to 24VAC or vice versa), you must remove and re-enrolled
the thermostat in the Z-Wave network for it to work correctly.
Adding the thermostat to a Z-Wave network.
1. Follow the instructions provided with your system for enrolling the thermostat.
2. Press and hold the FAN button on the Thermostat until the screen changes to
the Menu screen.
3. Press the UP button until ZWAVE is shown in the Status Display line then press
Select.
4. INSTALL should be shown on the status line.
5. When instructed by your system installation to add the thermostat to the network
press the “Select” button to install. Wait until SUCCESS or FAILED is shown on
the status display.
6. Press Done on the Thermostat to exit the ZWAVE screen.
7. Press Done on the Thermostat again to exit the Menu screen.
8. Once enrolled on your system’s network, continue to follow the instructions
provided to complete the enrollment and naming of the thermostat.
9. The
indicator should be shown on the Thermostat Main screen indicating
the thermostat has successfully been enrolled into the Z-Wave network.
Removing the thermostat from a Z-Wave network.
It may be necessary to remove and/or reinstall the thermostat from a Z-Wave network, if
the thermostat has been previously installed on another network.
Follow the instructions supplied with your Z-Wave system to remove/uninstall a Z-Wave
device. When the system instructs you to press and release the Z-Wave button on the
thermostat, follow these steps:
1. Press and hold the FAN button for 3 seconds until the Menu screen is displayed.
2. Press the UP arrow button to scroll to the “ZWAVE” menu.
3. Press “Select” to select the ZWAVE screen.
4. The display will show “REMOVE” in the text line.
5. Press “Select” to perform the remove action.
6. “WAIT” will be displayed in the text line. The remove operation is in process.
7. “SUCCESS” will be display when the reset is completed.
8. Press “Done” to exit back to the thermostat screen.
9. Thermostat is now ready to be added to the wireless network.