Installation Guide

DCN: 140-02338-01 DRAFT 20619

Page 14

Setting the Heating or Cooling Temperature Setpoint

Setpoint Change

To change the setpoint, press the Up or Down arrow buttons. The screen will switch to the

setpoint change screen (as above) and show the current setpoint of the current heating or

cooling mode. Adjust setpoint temperature up or down with the arrow buttons.

Note! When in the Setpoint Change screen, pressing the MODE button will switch

the setpoint being displayed between the Heat and Cool setpoints.

Setpoint Push: The cooling setpoint cannot be set below the heating setpoint. The

thermostat will “push” the heating setpoint lower if the cooling setpoint is set below the

current heating setpoint. A 3 degree separation is maintained between the heating and

cooling setpoints. The same is true for raising the heating setpoint above the cooling

setpoint. The thermostat will “push” the cooling setpoint up to maintain the 3 degree

separation.

Lower Temperature

Raise Temperature

Press either Up or Down

arrow button to go to the

Setpoint Change screen

Press “Done” (FAN button) to set the setpoint and exit back to the main

thermostat screen or wait for the screen to automatically time out.

Press the Up or Down arrow

buttons to set the desired

temperature setpoint

Pressing the Up or Down

buttons will change the

setpoint 1 degree. Press and

hold the button to ramp the

setpoint.

Setpoint being changed

Press MODE

button to change

from the heat

setpoint to the

cool setpoint