Vivian Element Installation Guide Getting Started Tools Needed Small Phillips screwdriver To avoid electrical shock and to prevent damage tithe furnace and thermostat, disconnect the power supply before installing or servicing the Thermostat any pat of the VAC system. This can be done af cheesecloth breaker labeled either furnace: oral handler £0 not fun power back on uli work is complete. Do not short Dumper) across electric terminals: af the control.an the furnace or air conditioner fo tes! Ihe system.
Vivian Element Installation Guide Getting Started Installation Location To avoid having to move your wir to g naw ligation; mount the thermostat in plate of the old thermostat. + Install the thermostat anon inside wall oftentimes-ased room, about 51 {1.
Vivian Element installation Guide Wiring or ee Read instructions carefully before removing any wiring rom an existing thermostat. Label alt wires before (Ionesco ting them form the existing thermostat Test existing thermostat before Turing of VAC power fo ensure VAC system is working appropriately 2 Turn off power fo the furnace or alr handler (le. beating and cooling systems).
Vivian Element Installation Guide Wiring Attaching the Mounting Plate to the Wall , Gars fully pull Whe Belled Wires thigh the center hole ir the moonlighting plate. . Position thermostat for best appearance fo cover the hole in the wall Lark first and drill 2 % In, Boom) hole at each screw location. 5 Bow LH you are pouring the Thermostat to sheet wool i you are using the old mounting holes, wise the plastic anchors provided. 5.
Vivian Element Installation Guide Wiring 0 Prepare Wires Make sure your wires are labeled. If necessary, find the “other and” connection {or each wire on your furnace of gir handler {Le healing or aif conditioning) equipment and heathen fae! there. 1. Fan out wires so that they are aligned with: the terminals. 2. Da hoot Bunch Wigs in Bonn of the mounting plate. Feed any stalk backing the wall. if dual transformer not grow wires to touch wires), remove perjurer.
Vivian Element Installation Guide Wiring Connecting Your Wires Reference the Metaled Wire Diagrams on page 28 certitude your weeing diagram and set-up formation, If necessary, contact customer support for help: 1. Cones a labeled wire only © skateboarding lettered terminal, 2. Insert the terminal labeled wire with corresponding terminal. (ey, Guise goes to G terr rial) 3. Make sire to insert the wire inch the eternal as far 461 will go, The wire should be sere and cannot be removed easily.
Vivian Relent Installation Guide Wiring Power Supply 4: Install four HAA alkaline batteries following the marked polarity in the battery compartments. Insert the battery initiative end First against the spring, thee push the positive snd in, 2 With all the quirks connected and the unit attached to the wall, it is tme: to tors the furnished andiron air handler power back on. Reconnect the power at the breaker your weed to switch off. This Thermostat will power-op: in the OFF mode.