Quick Start Guide RESERVA-EDGE-10T-W ONELAN Ltd, Bryants Farm Kiln Road , Reading. RG4 9PB United Kingdom www.onelan.com ~ www.reservaroomsigns.com support@onelan.
Quick Start Guide Thank you for choosing the Reserva Edge Interactive meeting room sign. Please follow the instructions to install and configure your room sign. Reserva Edge include several options for cable routing. 1. 2. 3. 4. Downwards towards the floor Upwards towards to the ceiling Left or right e.g. to a door frame Rearwards into a wall cavity These options are pictured below. Figure 1 - Cable management options for the Reserva Edge ONELAN Ltd, Bryants Farm Kiln Road , Reading.
Hardware install steps: Remove security screws with the tool provided Mark install height of ~ 125cm/49” from floor to top edge of wall mount If using screws to install, ensure mount is level and mark 4 x holes. For reference, the hole spacing is 103 * 230mm. If cables are to be routed back into wall cavity mark cable outlet also. If mounting with adhesive e.g. for glass, skip this step Drill 4 x 3mm pilot holes and clearance holes for cabling. If mounting with adhesive e.g.
If mounting to a surface which cannot be drilled e.g. glass, apply the double sided adhesive supplied as picture below. Press firmly to ensure a strong bond. If cabling is to be routed through lower cable exit or back to cavity wall, thread cables through the mount before fitting. For cabling to the left, right or above route cables through the channel on the back of the display. Secure using 3 x tape strips provided If mounting with screws, use a screw driver to secure the mount to the wall.
Attach all required cables Located the display on the mount stand offs and gently push the display downwards Use the supplied tool and security screws to secure lock the display in place Once power is connected the Reserva Edge room sign will boot automatically and obtain an IP address from the network. Follow the steps in the Install and Admin guide to fully setup calendar integration and connect room signs to Reserva Connection Manager. Cleaning Clean with a damp cloth.
*If using Power Over Ethernet, an 802.3at POE+ switch or injector must be used with a minimum power budget of 22W. If connected to mains power the socket-outlet shall be installed near the equipment and shall be easily accessible. ** see over the page for instructions on connecting to Wi-Fi Follow the simple 3 step process for configuring the Reserva Edge room sign: 1. Download and install Reserva Connection Manager (RCM) from www.reservaroomsigns.com/support 2.
Technical and regulatory information AC Power Adapter: Input: 100-240Vac, 50-60Hz, 1.0A MAX.; Class II Output: 12.0Vdc, 2.0A MAX.A (A) Environmental conditions Temperature Operating temperature: Non-operating: 32° to 104° F (0° to 40° C) 14° to 131° F (-10° to 55° C) Altitude (unpressurized) Operating Non-operating -50 to 10,000 ft (-15.24 to 3,048m) -50 to 40,000 ft (-15.
FCC This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
