User manual

A. Connect AZ motor:
Az motor Drive:
J2 on RC2000: Azimuth acuator/DC motor
AZ Drive 2; J2:6; black 14 AWG Negative terminals
AZ Drive 1; J2:4; red 14 AWG Positive terminal
B. Connect AZ sensor:
AZ sensor:
J1 on RC2000 AZ position sense/reed switch
AZ sensor Pulse; J1:7 Green
AZ sensor Ground; J1:6 Black
AZ sensor Shield; J1:6 shields No connect
Moving the antenna by pressing the AZ/CCW will always result in a decreasing
count value. Pressing the AZ/CCW button must result in AZ/CCW movement as
seen by an observer behind the antenna. In the Northern hemisphere, AZ/CCW
movement corresponds to East movement. Verify correct antenna movement
while in LIMTS mode. Be sure to use caution (LIMITS mode has unrestricted
movement.)
C. Connect EL motor:
El motor Drive:
J2 on RC2000: Elevation Actuator/DC Motor
EL Drive 2; J2:3 black 14 AWG Negative terminals
EL Drive 1; J2:1 red 14 AWG Positive terminal
D. Connect EL sensor:
El sensor:
J1 on RC2000 EL Position Sense/Reed switch
EL sensor Pulse; J1:5 Blue
EL sensor Ground; J1:4 Black
EL sensor Shield; J1:4 shield No connect
Moving the antenna by pressing the EL/Down will always result in a decreasing
count value. Pressing the EL/Down button must result in EL/Down movement as
seen by an observer behind the antenna. Verify correct antenna movement while
in AZ/EL LIMTS mode. Be sure to use caution (LIMITS mode has unrestricted
movement.)