User manual

internal list, the user is presented with a longitude value also from the controller’s

internal list.

3. Screen reads: ‘Select Band. 0 – C, 1 – K, 2-C&K. Enter’

Select 1 for KU band.

4. The next screen prompts the user to specify the Pol CW/CCW position.

Skew the POL to the Horizontal position and press the H/7 key. The screen will

briefly say H POL set. Skew the POL to the Vertical position and press the V key

and the menu will display ‘DATA ACCEPTED’.

Repeat Steps 1-4 to program in additional satellites.

After programming in a pair of satellites, the user should repeatedly move

between those two satellites (at least 10 times) using the AUTO mode. Note the

AZ and EL positions associated with each satellite. At the conclusion of the

moves, manually peak up received signal strength on each of the satellites (using

MANUAL mode). Verify that the AZ and EL positions that result in peaking

signal strength is the same as the position associated with each satellite. IF NOT,

position counts from the actuator pulse position sensors are not being

accumulated properly. In most cases, this is caused by improper shielding of the

sensor cable. Ensure that the actuator drain wires are connected at the back of the

controller and that the actuator shield is not allowed to come into contact with any

metal object. If the actuator cable is spliced, the shield drain must also be spliced.