Operating instructions

RC2000 Antenna Controller Interface Box

Quan Model/Description Manufacturer Comments (Ref Designators)

1 240 Ohm, 1 Watt Resistor (R6)

5 150626 Connector Weidmuller 2 Position Screw Terminal Connector

9 150646 Connector Weidmuller 3 Position Screw Terminal Connector

2 Z320LA15A CKE 320 Volt Metal Oxide Varistor (MOV1,

MOV2)

2 7105U15SYZ3QE C & K SPDT (MOM-OFF-MOM) Switch (SW1, SW2)

1 or 2 KBPB-125 or KBPB-225 KB Electronics,

Inc.

DC Motor Drive Module, the KBPB-125 is

used with 120 VAC Versions of the Interface

Box, the KBPB-225 is used with 220/240 VAC

Versions of the Interface Box [2] [3]

2 6-32 x 3/8” Screw Phillips Head Screw for Latching Relay Socket

2 #6 Lockwasher Lockwasher for Latching Relay Screw

2 6-32 Small Outline Nut Nut for Latching Relay Screw

4 ??” Standoff Circuit Board is Mounted on These Standoffs

4 ?? Nut w/ Nylon Insert For Use with Standoff

4 ?? Screw Connects Standoff to the Mounting Panel

2 or 4 ?? Screw KBPB Mounting Screw [1]

2 or 4 ?? Washer Used with KBPB Mounting Screw [1]

2 or 4 ?? Lock Washer Used with KBPB Mounting Screw [1]

2 or 4 ?? Nut Used with KBPB Mounting Screw [1]

1 1414 PHL6LP Hammond Mfg. 12” x 12” x 6” NEMA 4 Enclosure with

Panel[4]

1 1418 N4D8 Hammond Mfg. 20”x20”x8” NEMA4 Encl. w/Panel [4]

4 Insulated Ring Terminal Crimp Type, #10 Stud, 10-12 AWG Wire Size -

Used for Motor and KBPB Chassis Ground

Connection

Notes

1 2 are used for the RC2K90INT-1, 4 are used for the RC2K90INT-2

2 Only one motor drive module is used for the RC2K90INT-1, two motor drives are used for the

RC2K90INT-2.

3 When a KBPB-225 motor drive module is used with a 90 volt DC motor the KBPB should be

modified as described in Section 4.4.4. It is not necessary to perform this modification on new

Interface Boxes if 220/240 VAC line voltage and 90 volt DC motors are specified when the interface

box is ordered (the modification is performed at the factory).

4 12x12x6 box used up to 3/4HP 115VAC or up to 1 ½ HP 230VAC systems. The 20x20x8 box is

used up to 1 1/2HP 115VAC or up to 3 HP 230VAC systems.