® PN 502-00100-04 CATC/2WSI Intelligent Two Way Serial Interface SOFTWARE PROGRAMMING AND Firmware Version 1.1.0.
-2- Detailed Diagram .................................................................................................................................................... 2 Hardware Connection ............................................................................................................................................. 2 Connection for RS-232 Control ..................................................................................................................
-3Both JP1 and JP2 should be configured the same way for proper operation. Certain models of Escient Fireball® will need to have the jumpers at JP2 removed completely. If you have problems with your unit locking up, please remove these jumpers. Please see the Audioaccess website for any additional information regarding your specific installation. Note: Please consult your manufacturer’s information to determine the correct connection of the below pins for proper send and receive of RS-232 data.
-4NOTE: The plug in J1 on the CATC/2WSI automatically disconnects power from the keypad bus – you do not have to disconnect the power wire between the Interface Board and the KPT.
-5- Interface Setup The 2WSI has the communication protocol built into the unit. Depending on which dipswitch selections are made within the interface will determine which device type it is controlling and which interface number this particular unit is. In this way you can have several interfaces “talking to” multiple devices on the same system. 1. 2. Remove two screws holding cover on. Remove cover.
-6- CATC Easy Touch II Programming The programming for the interface is self contained within the template file we have provided you. You should have downloaded and installed the v1.2a update and any additional updates available. Please check www.support.audioaccess.com for the latest download. The below instructions are generic instructions for any interface and template. Please see detailed instructions for specific instructions for each interface.
-73. Drag and Drop the device template screens (in this example we are using the ReQuest Interface screens) from the Screens Templates onto the RELEASE of the More button (or any button that you will use to navigate to the additional control screens for this device). This will automatically add the control screens into your project and add the correct GOTO action. You can rename this button at any time.
-8- Troubleshooting Symptom Possible Cause Solution No Feedback on CATC No Power on CATC/2WSI Check Power LED and Phoenix connections. Incorrect Dipswitch Settings for Device Type Check Dipswitch setting for device type Incorrect dipswitch setting for Interface Address Check CATC program and CATC/2WSI dipswitch setting and check for correct setting. They should match.
