User`s manual

7
up to 200 meters distance is allowed without extra power connect.
[ Application -2 – work as PoE Switch]
In Application -2, the switch cannot receive power from uplink port. A
local power connection is provided for PoE application.
The switch can deliver both power and data to PoE PD devices, e.g.
some IP cameras, IP phones, and WiFi APs. That will reduce the
construction cost for those applications, and make them become easy to
implement. The switch can auto-detect the connecting devices and
decide to send power or not. Only when correct PoE PD is connected,
power will be delivered on the cable. For non-PoE devices, only data
will be delivered - working like a normal Ethernet switch. If power
overload happens, power delivering will be stop automatically for safety.
No any configuration is needed - just plug-and-play.
The example below demonstrates the switch ability to connect in a
network. Some IP cameras, IP phones, and WiFi APs are connected.
Power and data are delivered to them at the same time. Network traffic
will be transferred by the switch to network.
No any setup or configuration is needed. Just complete the network
connection. Then it works.
About some PoE application limitation, please refer to the chapter
“Installation Guide & Application Note”.