User`s manual

6
3. Configure Network Connection
3.1 Connecting to the Switch
[ Connection Guidelines: ]
 Cat. 5, 5e, or higher twisted-pair Ethernet cable for Ethernet network
connection.
 For TX cable connection, always limit the cable distance to 100
meters (328 ft) as defined by IEEE specification
 Because this switch supports Auto MDI/MDI-X detection on each TX
port, you can use normal straight through cable for both workstation
connection and hub/switch cascading.
*Note
: For PoE connection, crossover cable is not suggested
because Type A / Type B of PoE are different.
 PSE function of the switch on Port 1~4 is Type A design(PoE power
on pin 1,2,3,6). The PD should also support Type A connection for
PoE application. Both 802.3af and 802.3at PD devices are
supported.
 PD function of the switch on Uplink Port supports both Type A(PoE
power on pin 1,2,3,6) and Type B(PoE power on pin 4,5,7,8). It will
detect it automatically.
3.2 Application
[ Application -1 – work as PoE PD + PoE Switch ~ Extender]
In Application -1, the PoE+ Extender Switch receives both power and
data from uplink port that is connected to a PoE Switch. And four PoE
PD devices are connected to PSE ports of the switch. In such
application, one PoE connection is extended to four PoE connections and