User guide

To use the H264User first, you must input a name such as “Mike” into the settings (shown above) replacing
the “TIMHILLONE” , then click the “Check” button. If this H264 User has not been previously registered
you can click the “Create” button to apply the setting. At that point the H264 User Name “Mike” belongs to
you. When you start this program every time, this page will show “Mike’s” status with a “√” indicating this
H264User is OK. A “Χ” means this H264User verification has failed. A “?” means the status cannot be
determined. This can occur when the system is not connected to the network.
When you have a valid H264 User configured you can tell others and they can access the monitoring system
using the H264User name through the internet instead of an IP address.
Email Alert and Ftp Alert - Set-up Options
Click the button in the motion setting up section to enter this interface.