User`s manual

This page is used to configure LACP function. With LACP protocol, switches can
learn trunk connections automatically.
Follow the steps to do it. (*Don’t connect trunk cables until this function is set.)
a. Enable Trunk function at “Trunk Information” page first. Then click [Apply].
b. Assign System Priority. (Its value is 1~65535 and higher numbers have
lower priority. Combining with the Mac address of the switch, it is used to
identify this switch in LACP protocol operation.)
c. Select ports that will run LACP protocol.
d. Click [Apply].
Note
: If ports are already in static trunk group, they are not allowed to apply as
LACP ports. If static ports are selected as LACP ports, warning message will be
prompted when [Apply] is clicked.
3). Lacp Port Status
This is for LACP protocol running status.
You can see current port status with colors. If LACP trunk is created, another
port groups message will be shown.
Click [Refresh] can update the status information.
The following table will show the LACP enable/disable status of each port. And
the port number and port key of the partner switch will also be shown in the table
when LACP Trunk is running.
95