User`s manual

5). Rate Control
Two traffic rates could be controlled by the switch. One is the ingress/egress
traffic of each port. Another is Broadcast/Multicast/Unicast Storm Control.
5-1) Rate Control Configuration
This function can setup the ingress and egress rate limit of ports.
Follow the steps to configure ...
a. Set “Unit” first. It could be selected from pre-defined units, or define by
user. Click [Apply] after the setting.
b. Select the Port Number.
c. Enter the rate limit number for Ingress and Egress traffics. “0” means NO
LIMIT. Click [Apply] after the setting.
5-2) Storm Control Configuration
This function can setup the broadcast, multicast, and unicast storm rate of the
switch.
74