User`s manual

1. Select the port that you want to modify in “Port#” first.
2. Fill the name of the port.
3. Select Enable/Disable state in “Admin”. If Disable is selected, this port will
be disabled for any network access.
4. Select the Enable/Disable state of Auto function of port. The auto mode
could be auto-negotiation or auto-detect operation when auto is set to
disable.
5. If Auto is disabled, select the operation speed and duplex mode of the port in
“Speed/Duplex”.
6. Select the Enable/Disable state of Flow Control function of port.
7. Select the Enable/Disable state of Power Saving function of port. If it is
enabled, port will go to low power state when link down.
8. Click [Apply] after any modification.
2). Port Information
Current Setting & Link Status : It is current status of ports.
Name: The name of the port.
Admin: It shows current port enable/disable status.
Auto: It shows current Auto enable/disable status of ports.
Speed/Duplex: It will show current working speed and duplex mode if ports are
link up. Or the setting of speed/duplex when auto is disable.
Flow Control: It shows current Flow Control function status of ports.
Power Saving: It shows current Power Saving enable/disable status of ports.
Link: It shows the link status of each port.
3). Max Packet Length
72