User`s manual

(Http) could be enable/disable for different administrators. This is for security

policy for switch management.

Note:

Remember to enable at least one IP/Subnet with Modify right for Http

interface. Otherwise, configuring switch from remote will become impossible.

In that case, you have to use the “default” command from console to restore

settings to factory default for switch management.

2). Mac Security Configuration

There two Mac ID security modes for the switch. One is Static Mac ID Filter on

Port, another is Dynamic Mac ID Number Limit on Port.

[ Static Mac ID Filter on Port ]

This function can limit only those static Mac addresses on the port can access

network. Other Mac addresses will be rejected by the port. Sometimes it is

called “Mac-Port Binding”.

Follow the steps to configure it.

a. Set the “Security Control” to “Accept” on those ports that will apply static Mac

ID security. Then click [Apply].

b. Set Static Mac Addresses that are allowed for network access at [Static

Address] of [Address Table] function. Please refer to that section for the

details.

[ Dynamic Mac ID Number Limit on Port ]

This function can limit the Mac ID number to access network through a port. For

example, five Mac ID are allowed for Port 2. That means up to five users are

allowed, but don’t care who the users are.

Follow the steps to configure it.

a. Set the “Security Control” to “Limited by MAC no.” on those ports that will

apply dynamic Mac ID number security. And set the “Max. MAC no.” to the

users number allowed on the ports.