User`s manual

59
6.3 About Telnet and SNMP Management Interfaces
6.3.1 About Telnet Management Interface
If you want to use Telnet to manage the switch from remote site, you have to set
the IP/Mask/Gateway address to the switch first from console. Then use "telnet
<IP>" command to connect to the switch. Its operation interface is the same as
console interface.
6.3.2 About SNMP Management Interface
If you want to use NMS to management the switch from remote site, you have to
set the IP/Mask/Gateway address to the switch and configure the SNMP setting of
the switch from console first. Then you can use SNMP management program to
manage this switch.
This switch supports SNMP v1 & v2c agent function and MIB II(Interface), Bridge
MIB, 802.1Q MIB and Private MIB. The default GET community name is
“public” and SET community name is “private”.
This switch supports up to five trap receivers with different trap community
names.