User`s manual

56
show spanning-tree command is used to show all spanning tree configuration
(for bridge and ports).
show spanning-tree ethernet 1/x command is used show spanning tree
configuration of Port x. (“x” is the port number.)
For example,
# show spanning-tree ethernet 1/5
Bridge Port Number: 5
Port Priority (0..255): 128
Port State: Linked Down
Port Enable : Enabled
Is edge : No
Port Path Cost(1..65535): 19
Port Designated Root: 00:00:00:00:00:00 [ 0 ]
Port Designated Cost: 0
Port Designated Bridge: 00:00:00:00:00:00 [ 0 ]
Designated Port: 5: [ 128 ]
Port Forward Transitions: 0
Port Role: Nonstp
Point To Point: Yes
21. show system command
This command is used to show general system configuration of the switch.
For example,
# show system
System Configuration
Main Board Information:
Firmware Version: 1.01.09 (built at Aug 6 2008 14:38:24)
Mac Address: 00:C0:F6:64:99:6F
Number of Ports: 10
1Q VLAN Max. Group: 256
DHCP Client: Disable
Time Server: Disable
System Log Status: Disable
Remote Log: Enable
22. show trunk command
This command is used to show trunk configuration of the switch.
# show trunk ?
configuration Show Trunk Configuration
all Shows all Trunking Group Configuration
group Shows Each Trunking Group Configuration
show trunk configuration command is used to show trunk function
enable/disable setting.
show trunk all command is used to show port member settings of all trunk
groups.