User`s manual

For example,

# show port monitor

Destination port: 6

Source port: Eth1/2 Eth1/7

Mode : Disable

15. show queue command

This command is used to show traffic scheduling settings for queues on ports.

# show queue ?

bandwidth Shows weighted round-robin (WRR) bandwidth

mode Priority queue information

show queue bandwidth command is used to show weighting of priority queues

for bandwitdh sharing of WRR operation.

show queue mode command is used to show traffic scheduling mode for

priority queues. One is Strict Priority (higher priority always get bandwidth

service first), another is WRR (Weight Round Robin, bandwidth is shared

between queues with weighting).

For example,

# show queue bandwidth

Queue Scheduling

WRR Setting Table

Priority Weight

Traffic Class 0 1

Traffic Class 1 2

Traffic Class 2 4

Traffic Class 3 8

# show queue mode

Queue mode: Strict

16. show radius-server command

This command is used to show settings for RADIUS Server of 802.1x function.

For example,

# show radius-server

[Redius Server Configuration Menu]

Redius Server IP Address : 192.168.1.222

Redius Server Port Number : 1812

Security Key : 12345678

17. show rate-limit command

This command is used to show rate limit settings on ports.

For example,

# show rate-limit

[Rate Control Configuration]

Port Ingress Egress