User`s manual

53
Eth 1/ 3 0 N/A No Security
Eth 1/ 4 0 N/A No Security
Eth 1/ 5 10 0 Limited by MAC no
Eth 1/ 6 0 N/A No Security
Eth 1/ 7 0 N/A Accept function
Eth 1/ 8 0 N/A No Security
Eth 1/ 9 0 N/A No Security
Eth 1/10 0 N/A No Security
12. show management command
This command is used to show switch management security settings. The
IP/subnet, access mode, and protocol functions security settings will be shown.
For example,
# show management
[Management IP configuration]
Index Enabled Address / Net Mask Mode Http Telnet SNMP
====================================================================
1 Yes 0.0.0.0/0.0.0.0 Modify Yes Yes Yes
2 No 0.0.0.0/255.255.255.255 View No No No
3 No 0.0.0.0/255.255.255.255 View No No No
4 No 0.0.0.0/255.255.255.255 View No No No
====================================================================
13. show map command
This command is used to show 802.1P priority, DSCP priority, and port-based
priority to priority queues mapping. There are four priority queues on each port
of the switch.
# show map ip ?
dscp IP DSCP priority map
port IP port priority
precedence IP precedence priority map
show map ip dscp ethernet 1/x command is used to show DSCP
values(0~63) to priority queues mapping on Port x. (“x” is the port number.)
show map ip port command is used to show port to priority queues mapping.
This is called port-based priority.
show map ip precedence command is used to show 802.1P priority
values(0~7) to priority queues mapping on all ports.
show map ip precedence ethernet 1/x command is used to show 802.1P
priority values(0~7) to priority queues mapping on Port x. (“x” is the port
number.)
14. show port command
This command is used to show port mirror function setting.
show port monitor command is used to show port mirror function setting.