User`s manual

52
Eth 1/3 00-C0-F6-01-15-87 Learned
Eth 1/3 00-90-CC-82-A5-D6 Learned
Eth 1/3 00-00-E2-82-8C-E6 Learned
show mac-address-table aging-time command will show aging time of mac
address table.
For example,
# show mac-address-table aging-time
Status: Enable Aging time: 300 sec
show mac-address-table address x-x-x-x-x-x command will show the mac
address table for mac address “x-x-x-x-x-x”.
For example,
# show mac-address-table address 00-00-e2-82-8c-e6
Interface MAC Address VLAN Type
=================================================
Eth 1/3 00-00-E2-82-8C-E6 Learned
show mac-address-table interface ethernet 1/x command will show the mac
address table for Port x. (“x” is the port number).
For example,
# show mac-address-table interface ethernet 1/3
Interface MAC Address VLAN Type
=================================================
Eth 1/3 00-00-01-00-00-20 Learned
Eth 1/3 00-90-CC-82-A5-D6 Learned
Eth 1/3 00-00-E2-82-8C-E6 Learned
Eth 1/3 00-C0-F6-01-04-28 Learned
show mac-address-table multicast command will show multicast address
table for IGMP function.
For example,
# show mac-address-table multicast
Group VID Group Address Members Port
----- --- --------------- -------------
11. show mac-security command
This command is used to show mac address security settings on port. There
are two mac address security functions for ports. One is “accept” mode that
allows static mac addresses on ports to access network only. Another is “limit
by mac no.” mode and up to a limit number of mac addresses are allowed to
access network from the port.
For example,
# show mac-security
[MAC Security Configuration]
===========================================================
Port# Max. MAC no. Learned no. Security Control
Eth 1/ 1 0 N/A No Security
Eth 1/ 2 0 N/A No Security