User`s manual

51
9. show logging command
This command is used to show current system log and system log configuration.
# show logging ?
configuration logging configuration
<cr>
show logging command is used to show current system log content.
For example,
# show logging
[5] Thu Jan 01 09:00:02 1970
Level: 4 System Started [port 0]
[4] Thu Jan 01 09:08:20 1970
Level: 4 Link down [port 8]
[3] Thu Jan 01 09:07:50 1970
Level: 4 Link up [port 8]
[2] Thu Jan 01 09:07:45 1970
Level: 4 Link down [port 8]
[1] Thu Jan 01 09:00:06 1970
Level: 4 System Started
show logging configuration command is used to show current system log
configuration.
For example,
# show logging configuration
[System Log]
System Log Status : Disable
Log Level(0-7): 4
Remote Log : Enable
Remote Log Server IP : Empty
10. show mac-address-table command
This command is used to set Mac address table and configuration about it.
# show mac-address-table ?
aging-time Aging time for entries in the address table
address Address information
interface Ethernet or port channel-interface
multicast Knowns multicast addresses
<cr>
show mac-address-table command will show mac address content.
For example,
# show mac-address-table
Interface MAC Address VLAN Type
=================================================
Eth 1/3 00-00-01-00-00-20 Learned
Eth 1/3 00-0E-A0-00-03-28 Learned
Eth 1/3 00-90-08-A7-76-C6 Learned
Eth 1/3 00-C0-F6-01-11-40 Learned
Eth 1/3 00-80-C8-BF-10-D2 Learned