User`s manual

46
6.2.6 Show Commands
Show command is put in General Basic Commands for viewing system
configuration and information.
Enter “show ?” at the prompt, the sub-command list will be shown.
# show ?
calendar Date and time information
dot1x 802.1x content
gvrp GVRP configuration
history History information
interface Interface information
ip IP information
lacp LACP statistics
line TTY line information
logging Login setting
mac-address-table Configuration of the address table
mac-security MAC Security Configuration
management Management IP filter
map Maps priority
port Port characteristics
queue Priority queue information
radius-server RADIUS server information
rate-limit Configures rate-limits
snmp Simple Network Management Protocol statistis
sntp Simple Network Time Protocol configuration
spanning-tree Spanning-tree configuration
system System information
trunk Trunk information
version System hardware and software versions
vlan Virtual LAN settings
1. show calendar command
This command will show current system time.
For example,
# show calendar
Current Time : 2008/08/29-11:27:12
2. show dot1x command
This command is used to show 802.1x configuration and status.
show dot1x command is used to show current 802.1x configuration and status
of each port. For example,
# show dot1x
[Port Authentication Configuration]
Port Status Authentication Mode
1/1 Force-Authorized
1/2 Force-Authorized
1/3 Yes Force-Authorized
1/4 Force-Authorized
1/5 Force-Authorized