User`s manual

34
10. end command
This command is used to exit from interface mode.
(config-if)# end
(config)#
11. flowcontrol command
This command is used to enable flow control function of the interface port(s).
flowcontrol command is used to enable flow control function of the interface
port(s).
no flowcontrol command is used to disable flow control function of the
interface port(s).
12. interface command
This command is used to change the interface port(s) or interface VLAN groups
for next setup commands.
(config-if)# interface ?
ethernet Ethernet port
vlan Switch Virtual LAN interface
For example,
“(config)# interface ethernet 1/5” will set current setup interface to Port 5 and all
the commands will be applied to Port 5.
“(config-if)# interface ethernet 1/6-7” will change current setup interface to Port
6-7 and all the commands will be applied to Port 6-7.
If “vlan” sub-command is used, current setup interface will be changed to some
VLAN groups. For example,
“(config-if)# interface vlan 100” will change current setup interface to VLAN 100
and all next commands will be applied to VLAN 100.
The description of commands in interface configuring mode is put in Section
6.2.4 Interface Configuring Commands. Please refer to the section for the
details.
13. lacp command
This command is used to enable LACP protocol working on the interface
port(s).
lacp command will enable LACP protocol working on the interface port(s).
no lacp command will disable LACP protocol working on the interface port(s).
If the interface port(s) are already assigned to trunk by “channel-group”
command, its LACP function will be ignored.