User`s manual

32
“interface ethernet 1/1,2,4-7” and the settings after this command will be
applied to Port 1, Port 2, Port 4, Port 5, Port 6, and Port 7. (Port 4~7)
Entering “interface ethernet 1/5”, and its prompt will become ...
(config)# interface ethernet 1/5
(config-if)#
Enter “?” at the prompt, the sub-command list will be shown.
----------------------------------------------------------------------------------------------
(config-if)# ?
exit Exit from current mode
help Show available commands
history Show a list of previously run commands
logout Disconnect
quit Quit commands
channel-group Adds a port to a trunk
description Interface specific description
dot1x Configures 802.1x port-based access control
duplex Configures duplex operation
end Exit from interface mode
flowcontrol Enables flow control during autoneg
interface Enters privileged interface configuration
lacp Configures LACP status
map Maps priority
maximum-packet-length Configures the maximum packet length of the port
no Negates a command or sets its defaults
port Configures the characteristics of the port
port-vlan Configures Port-Based VLAN
qos Configuration of QoS
rate-limit Configures rate-limits
shutdown Shuts down the selected interface
spanning-tree Specifies spanning tree configuration
speed Configures speed operation
switchport Configures switching mode characteristics
----------------------------------------------------------------------------------------------
1. exit command
This command is used to leave current operation mode. Go back to last
mode.
2. help command
This command is used to show all the available commands in this mode.
3. history command
This command is used to show the entering command history.
4. logout command
This command is used to logout from console interface.