User`s manual

30
The trunk function for the switch works with LACP protocol. The system
priority of LACP is set by “lacp” command. And the settings on ports is done in
“interface” command.
29. username command
This command is used to set the username and password for administrator and
guest.
username admin www xxx yyy zzz command is used to set the username
and password for administrator. “www” is the old username. “xxx” is the old
password. “yyy” is the new username. “zzz” is the new password.
username guest yyy zzz command is used to set the username and password
for guest. “yyy” is the new username. “zzz” is the new password.
Administrator is the user who has the right to do configuration modification.
Guest is the user who has the right to view configuration only.
30. vlan command
This command is used to enter VLAN configuring mode. And the prompt will
become ...
# vlan database
(config-vlan)#
The operations for VLAN are done in VLAN configuring mode. Please refer to
6.2.5 VLAN Configuring Commands section for the details.