User`s manual

2. help command

This command is used to show all the available commands in this mode.

3. history command

This command is used to show the entering command history.

4. logout command

This command is used to logout from console interface.

5. quit command

This command is used to quit from console interface. It has the same function

as logout.

6. automode command

With the command, user can select the operation mode of port when “auto” is

set to disabled.

For “Auto Negotiation” mode, the switch will disable port auto-negotiation

function when the auto function of port (in Port Configuration setting) is

disabled.

For “Auto Detect” mode, the switch will always keep port auto-negotiation

function ON but just modify its attribution if auto function of port (in Port

Configuration setting) is disabled.

For applications, you should select “Auto Detect”mode if the connected device

is auto-negotiation enabled. (For example, customer’s PC is auto-negotiation

enable and you want to set his network connection to work at 10Mbps.)

And you can select “Auto Negotiation”mode if the connected device is auto-

negotiation disabled (it is called forced mode, sometimes). Some old TX-FX

Converters needs to work in this mode because FX supports 100/Full forced

mode only. For most applications, “Auto Detect” mode is OK.

With “automode ?”, the sub-commands will be shown.

(config)# automode ?

detect Auto Detect mode

negotiation Auto Negotiation mode

automode detect command will set it to auto-detect mode.

automode negotiation command will set it to auto-negotiation mode.

7. default command

This command is used to restore factory default settings. Before start it, a

confirm message wil be prompted.