User`s manual

17
logging Login setting
mac-address-table Configuration of the address table
mac-security MAC Security Configuration
management Management IP filter
map Maps priority
port Port characteristics
queue Priority queue information
radius-server RADIUS server information
rate-limit Configures rate-limits
snmp Simple Network Management Protocol statistis
sntp Simple Network Time Protocol configuration
spanning-tree Spanning-tree configuration
system System information
trunk Trunk information
version System hardware and software versions
vlan Virtual LAN settings
With sub-commands, different configuration settings will be displayed.
More help information for them will be prompted with “show xxxx ?” (xxxx is the
sub-command). For example, entering “show ip ?” will get the prompt
message...
# show ip ?
igmp IGMP snooping
interface Interface information
redirects Default gateway configured for this device
And entering “show ip igmp ?” will get next help message...
# show ip igmp ?
snooping IGMP snooping configuration
And entering “show ip igmp snooping” will get the IGMP settings...
# show ip igmp snooping
IGMP Status: Disable
IGMP Querying: Disable
IGMP Querying: Disable
IGMP Query Interval: 125 seconds
IGMP Report Delay: 15 seconds
IGMP Query Timeout: 255 seconds
If the display is more than one console page, “Esc” can be used to break the
display.
For the details, please refer to section 6.2.6 Show commands.
11. calendar command
This command is used to set the system time. It is entered in the <hour minute
second month day year> order.
For example,
# calendar set 10 30 0 october 15 2008
# show calendar
Current Time : 2008/10/15-10:30:18