User`s manual

16
Enter “ping ?” at the prompt, the command syntax will be shown.
# ping ?
Syntax: ping [-n count] [-l length] [-t] [-w timeout] ip
-n count : Number of echo requests to send.
-l length : Send buffer size, and length is between 64~8148
-t : Ping the specified host until stopped by <ESC> key.
-w : Timeout in milliseconds to wait for each reply.
ip : IP address (xxx.xxx.xxx.xxx)
For example, “ping 192.168.1.80”. “Esc” can be used to break continuous ping
operation.
6. quit command
This command is used to quit the console interface.
7. disable command
This command is used to leave privileged mode, and the prompt will become
“>”. Only the guest access right is available.
8. enable command
This command is used to enter privileged mode, and the prompt will become
“#”. And the administrator access right is available.
9. reload command
This command is used to reset switch. It will halt and perform a warm restart
Enter “reload” at the prompt, you will be asked to confirm the action.
# reload
Are you sure to reset switch now?(Y/N)
If “y” is entered, the switch will reboot. If “n” is entered, just leave and no any
action will go.
10. show command
This command is used to show current system information and system
configuration.
Enter “show ?” at the prompt, the sub-command list will be shown.
# show ?
calendar Date and time information
dot1x 802.1x content
gvrp GVRP configuration
history History information
interface Interface information
ip IP information
lacp LACP statistics
line TTY line information