User Manual

Connection Diagram

You can follow below steps to connect your system:

Step 1: Connect the NVR to a Monitor or TV

Use the HDMI cable (supplied) to connect your NVR to the TV’s HDMI port.

.(If there is no display, please connect it to a VGA monitor and change its resolution to

1920*1080). If you need audio output on your TV monitor, the resolution MUST be set to

1920*1080 or 1280*720.

Or VGA: Use the VGA cable (supplied) to connect your NVR to the Monitor’s VGA port .

Step 2: Connect the IP Cameras

Connect the camera’s RJ45

network socket to any POE Camera

port on the NVR using the Ethernet

cables provided.

You may also purchase longer

LAN cables if required. The

system supports up to 330ft

CAT 6 cables.

Camera Reset button: It enables you to reset the camera’s admin password back to

factory default settings.

Please make sure POE Cable is 8 pin network Cable, for some Cable is 4 pin only. 4

Pin cable cannot be used for POE Camera.