Tus neeg siv phau ntawv

Set up the Camera
4EnglishEnglish
Camera Introduction
Meaning of the Status LED:
It is recommended that the initial setup be completed with the Ethernet cable. You may follow the
steps below to set up your camera.
Step 1 Connect the camera to a LAN port on your router with an Ethernet cable.
Step 2 Use the power adapter provided to power on the camera.
Power AdapterRouter
Your Smart Device
Reolink E1 Outdoor
Power CableNetwork Cable
Wired Setup
WiFi connection failed
Status/LED
LED in Blue
WiFi is not configured
Camera is starting up
WiFi connection succeeded
SolidBlinking
Power Cable
Daylight Sensor
Spotlight
Micro SD Card Slot
Lens
Built-in Mic
Reset Button
* Rotate the lens to find the
reset button and the SD card slot.
* Press for more than five seconds to
restore the device to default settings.
Infrared Lights
Status LED
Network Cable
Speaker
3