A u g u s t 2 02 2 QSG1_A_EN Quick Start Guide Apply to: Reolink Floodlight WiFi 58 . 03 . 0 0 1 . 0275 @ R e o l i n kTe c h h t t p s ://re o l i n k .
EN Content What's in the Box What's in the Box 2 Floodlight Introduction 3 Set up the Floodlight 5 Install the Floodlight 6 Troubleshooting 8 Specification 8 Notification of 8 Compliance 8 Floodlight Mounting Plate Mounting Hole Template Power Adapter * 1m Ethernet Cable 4.5m Power * Extension Cable Pack of Screws Quick Start Guide NOTE: * The power adapter and 4.5m Power Extension Cable only come with WiFi Version.
Floodlight Introduction WiFi Version Speaker Daylight Sensor PIR Sensor Status LED LAN Port Reset Button * Press the reset button with a pin to restore factory settings.
Set up the Floodlight Install the Floodlight Download and launch the Reolink App or Client software, and follow the onscreen instructions to finish initial setup. • Install the Floodlight 2-3 meters (7-10 ft) above the ground. This height maximizes the detection range of the PIR motion sensor. • On Smartphone • For better motion detection performance, please install the floodlight angularly. Scan to download the Reolink App.
Mount the Floodlight to the Wall Troubleshooting If the problem is not solved, please contact Reolink Support. Floodlight is not powering on Specification If your Floodlight is not powering on, please try the following solutions: Hardware Features Light: 40pcs/18W Dimension: 216X118X160mm Weight: 635g Working Temperature: -10°C~+55°C (14°F~131°F) 1 2 Notification of Compliance 1. Drill holes in accordance with the mounting template. 2.
interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device. L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence.
