Operation Manual

Machine Head
Bend Module
Addional Bend Module
Addional Bend Die
Bend Module Bolt
Machine Handle
Release Lever
Oil Plug
Reference Bolt
Dabber
Pump Case
Motor Housing
Brush Caps
Note: Reference bolt can be used as a reference
point against bend module posion during bending.
Installing Addional Bend Module and Bend Die
1. Disconnect from power supply.
2. Unfasten bend module bolt and remove exisng bend module.
3. Fit addional bend module over dabber and securely fasten addional bend module bolt (bolt
must line up with groove in dabber).
4. Fit addional bend die over exisng machine head and securely fasten addional bend die bolt.
MODEL RB-16
Input Voltage -Single Phase 220-240V AC ~50Hz or 110-120V AC ~60Hz *
Power Consumpon
850W (220-240V)
1000W (110-120V)
Net Weight 15kg
Dimensions (cm) 60L x 17W x 20H
Bending Range 4-16mm**
Machine Specicaons
* Check machine label to determine correct power supply.
**Refer to machine model data sheet for maximum tensile strength/grade.
Machine Parts