Operation Manual
WARNING: PLEASE READ THIS MANUAL
CAREFULLY BEFORE USING THIS MACHINE
Machine is not rated and should not be used for commercial rebar producon purposes.
1. Safety
This machine is a high performance, electric tool. Failure to follow safety instrucons may result
in serious injury.
1. Authorized personal protecve equipment must be worn when operang machine (minimum
requirement - protecve gloves).
2. Take note of all warning signs on machine.
3. Keep body parts well clear of moving parts when machine is switched on.
4. Do not touch pump housing aer use as it will be hot. Wait for machine to cool.
5. Use away from others, parcularly children.
6. Never aempt to bend rebar outside of models prescribed diameter range (refer to table in
Specicaons & Parts secon).
7. Hold bender rmly and maintain proper foong and balance. Do not use at heights.
8. Never operate machine in wet or damp condions.
9. Never aempt to service machine (other than general maintenance procedures outlined in
Maintenance secon). Contact supplier if issues arise.
10. Only use REO-MECH approved spare parts and accessories with machine.
11. Do not bend short lengths.
12. Keep away from sparks and naked ames.
13. Always check power cord for damage and safe placement prior to use.
14. Disconnect bender from power outlet when not in use.
15. Inspect bender before each use (refer to Maintenance secon). Do not use when quality has
been compromised.
16. Do not cover air vents on machine.
17. Store out of reach of children.
2. Specicaons & Parts
Power Supply:
Ensure machine is connected to correct power supply (check machine label to conrm power
supply).
Extension Leads:
Where possible, connect machine directly to power outlet. If an extension lead is required,
ensure lead is under 35m in length. Minimum extension lead diameter are prescribed below:
Extension Lead
Length (m)
Min Wire ø (mm²)
25m 1.0
35m 1.5