Operation Manual

3. Operang Machine
Pre-use Checks:
1. Check oil level (refer to Maintenance secon).
2. Check condion of cuer blocks and ghtness of cuer block bolts (refer to Maintenance
secon).
3. Check power supply is properly earthed.
4. Check that power cord is undamaged and plug is not loose (also applies for extension leads).
Warm Up:
In cold weather, warm up unit for 60 seconds to ensure hydraulic oil reaches proper viscosity.
Pull trigger and repeat cut cycle without material 15-20 mes.
Stopper Adjustment:
Adjustable stopper must be set in correct posion dependent on size of rebar.
1. Insert rebar into U-shaped support.
2. Keeping rebar at 90⁰ to machine, screw in stopper unl it is just touching the rebar.
Cung Procedure:
1. Insert rebar between stopper and front cuer block, making sure it is properly seated in
U-shaped support.
2. Pull and hold trigger while cuer rod advances and fully cuts rebar.
3. Release trigger only once rebar has been fully cut to allow cuer rod to retract.
Note: Power will be compromised if hydraulic oil exceeds 70˚C. Allow machine to cool before
resuming operaon.
4. Maintenance
Cuer Blocks:
Check cuer blocks for damage before each use. If cuer block is damaged, replace block before
next use as per following diagram:
Check cuer block bolts for ghtness before each use. Use protecve gloves when handling
cuer blocks as edges are very sharp.
Ensure cuer block with
at edges installed here.
Ensure cuer
block with
rounded edges
installed here.
Fix longer cuer block bolt pair here
Fix shorter cuer block bolt pair here