Operation Manual

1. Safety
This machine is a high performance, electric tool. Failure to follow safety instrucons may result
in serious injury.
1. Authorized personal protecve equipment must be worn when operang machine (minimum
requirement - safety glasses and protecve gloves).
2. Take note of all warning signs on machine.
3. Ensure power supply is properly earthed.
4. Keep body parts well clear of cuer blocks when machine is switched on.
5. Beware of ejected objects during the cung process. Always wear approved safety glasses.
6. Use protecve gloves when cleaning machine or handling cuer blocks as edges are very sharp.
7. Do not touch pump housing aer use as it will be hot. Wait for machine to cool.
8. Use away from others, parcularly children.
9. Never aempt to cut rebar outside of models prescribed diameter range (refer to table in
Specicaons & Parts secon).
10. Never aempt to service machine (other than general maintenance procedures outlined in
Maintenance secon). Contact supplier if issues arise.
11. Only use REO-MECH approved spare parts and accessories with machine.
12. Do not cut short lengths.
13. Hold cuer rmly and maintain proper foong and balance. Do not use at heights.
14. Never operate machine in wet or damp condions.
15. Keep away from sparks and naked ames.
16. Always check power cord for damage and safe placement prior to use.
17. Disconnect cuer from power outlet when not in use.
18. Inspect cuer before each use (refer to Maintenance secon). Do not use when quality has
been compromised.
19. Do not cover air vents on machine.
20. Store out of reach of children.
21. Where available, safety guard should be installed.
2. Specicaons & Parts
Power Supply:
Ensure machine is connected to correct power supply (check machine label to conrm power
supply).
Extension Leads:
Where possible, connect machine directly to power outlet. If an extension lead is required,
ensure lead is under 40m in length. Minimum extension lead diameter are prescribed below:
Extension Lead Length (m) Min Wire ø (mm²)
25m 1.5
40m 2.5
WARNING: PLEASE READ THIS MANUAL
CAREFULLY BEFORE USING THIS MACHINE
Machine is not rated and should not be used for commercial rebar producon purposes.