Full Product Manual

Important Safety Information
01
Important Safety Information
The user manual provides important installation, operation, and maintenance instructions for
12V 700W/1000W/2000W/3000W Pure Sine Wave Inverter. Please read the user manual
carefully before installation and operation and save it for future reference.
Failure to observe the instructions or precautions in the user manual can result in electrical
shock, serious injury, or death, or can damage the inverter, potentially rendering it
inoperable. The installation and service of the inverter might require knowledge of electricity
and is recommended to be carried out by qualified personnel.
Symbols Used
The following symbols are used throughout the user manual to highlight important
information:
WARNIN
G
Indicates a potentially dangerous condition which could
result in injury or death.
CAUTIO
N
Indicates a critical procedure for safe and proper installation
and operation.
NOTE
Indicates an important step or tip for optimal performance.
INFO
Indicates that more information is available in other
documents relating to the subject.
General Safety Information
WARNIN
G
z
Have the inverter installed by a qualified technician in accordance with the local and
national electric codes (NEC).
z
There are no serviceable parts for this inverter. Do not disassemble or attempt to repair
the inverter.
z
Ensure all connections going into and from the inverter are tight. There may be sparks
when making connections; therefore, there should not be flammable materials or gases
near the installation site.
z
The inverters are suitable for 12V battery banks ONLY.
z
Always ensure the inverter is in OFF position and disconnect all AC and DC devices
associated with the inverter.
z
Never connect the AC output of the inverter directly to an Electrical Breaker Panel or
Load Center which is also fed from the utility power or generator.
z
Please confirm the polarity of the devices before connection. A reverse polarity contact
can cause injury and damage the device.
z
Be careful when touching bare terminals of capacitors as they may retain high lethal
voltages even after power is removed.
Symbols Used General Safety Information