Full Product Manual

Operation
24
Operation
Operations on Inverter
After proper battery and AC load connections, you can operate the inverter.
1. On the AC side, rock the ON/OFF Switch to the ON position.
2. The inverter is operating normally.
3. When finishing using the inverter, power off the AC loads first, and then rock the ON/OFF
Switch to the OFF position.
CAUTION
z
When the inverter turns on, it is normal to hear the fans run for a second and hear a
beep.
z
Avoid powering on the inverter with the load (electronic devices) already switched on.
This may trigger an overload since some electronic devices have an initial high power
surge to start.
z
When switching off the inverter, turn off the electronic devices first. Although the inverter
is off, the terminal capacitors will still have a charge, so the DC and AC terminals must
be disconnected if altering the circuitry.
Wired Remote Control
The Wired Remote Control gives you the opportunity to power on/off the inverter from a
distance (approximately 16.4 ft / 30.5 mm).
Note that the inverter ON/OFF switch should be in the REM position.
ERR
RMS-P2
ON
2.1.1
1. Connect the Wired Remote Control to the inverter via the
Remote Control Connector.
2.1.2
2. Rock the ON/OFF Switch to the REM position, and you
can power on/off the inverter via the Wired Remote
Control.
Operations on Inverter Wired Remote Control