Full Product Manual

Battery GEL SEALED FLOODED LI (LFP) USER
High Voltage
Disconnect
16 V 16 V 16 V 16 V
Equalization
Voltage
----- -----
14.6 V
Boost Voltage
Float Voltage 13.8 V 13.8 V 13.8 V -----
Boost Return
Voltage
13.2 V 13.2 V 13.2 V 13.2 V
Low Voltage
Reconnect
12.6 V 12.6 V 12.6 V 12.6 V
Under Voltage
Warning
12 V 12 V 12 V 12 V
Low Voltage
Disconnect
Equalization
Duration
2 hours 2 hours
Battery Charging Parameters
Voltage
Discharging Limit
Boost Duration
2 hours 2 hours 2 hours -----
----------
9-17 V
9-17 V
9-17 V
9-17 V
0-10 Hrs.
1-10 Hrs.
9-17 V
9-17 V
9-17 V
9-17 V
9-17 V14.8V
14.4 V14.6 V 14.4 V 14.2 V
11.0V 11.0V 11.0V 11.0V
10.6 V 10.6 V 10.6 V 10.6 V
*Battery charging parameters in LI mode and USER mode can be programmed using the
Solar Monitoring Software or Renogy BT App.
This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
**Default charging parameters in LI mode are programmed for 12.8V LFP battery. Before
using Rover to charge other types of lithium battery, set the parameters according to the
suggestions from battery manufacturer.
***Parameters are multiplied by 2 for 24V systems.