Full Product Manual

17
6. Test Mode
Use to cycle through the screens. Press to select
Test the load of the charge controller. Once settings
have been set in 4. Load Set, the user is able to test
whether the load will turn on upon direction.
NOTE: Delay must be set to “0” to see immediate
results.
7. Password
Use to cycle through the screens. Press to select
Setting a password for the controller prohibits the user
from programming the controller unless the password
is set.
NOTE: Default Password is “00000” if it prompts the
user to enter a password before they set one.
8. Batt Mng Mode
Use to cycle through the screens. Press to select
Voltage Compensation and State of Charge Battery
Managing modes to determine battery charge status.
NOTE: It is not possible to measure actual SOC, but rather express it as a percentage of some
reference. In this case it is voltage alone (VC) or battery capacity over a time span (SOC).
VC. converts a reading from battery voltage to determine SOC by utilizing the charge
controller’s algorithm for known discharge. It is highly sensitive to temperature changes and battery
disturbances thus having less accurate battery charge statuses.
SOC is more accurate by keeping track of the voltage and current flow in and out of the battery
when reporting battery charge status. The SOC is determined by multiplying current by the time for
which it flowed.
9. Factory Reset
Use to cycle through the screens. Press to select
Reset the controller to factory settings. This will erase
any customized parameters the user may have set.
Test Mode
Load: > ON OFF
Password
Ori.PSW: 000000
NewPSW: 000000
Factory Reset
>NO YES
ENTER/ 
 / -
 / 
ENTER/ 
 / -
 / 
ENTER/ 
 / -
 / 
ENTER/ 
 / -
 / 
Batt Mng Mode
>V.C. SOC