Full Product Manual
11
MT-50 Tracer (If applicable)
Mounting Recommendations:
WARNING: Never install the controller in a sealed enclosure with flooded batteries. Gas can
accumulate and there is a risk of explosion.
1. Choose Mounting Location—place the controller on a vertical surface protected from
direct sunlight, high temperatures, and water. Make sure there is good ventilation.
2. Check for Clearance—verify that there is sufficient room to run wires, as well as
clearance above and below the controller for ventilation. The clearance should be at least
6 inches (150mm).
3. Mark Holes
4. Drill Holes
5. Secure the charge controller.
1
2
6 inches
(150mm)
6 inches
(150mm)